I have several hard plastic items that have really nice
textures. In the past, I would roll my
clay out on the textures hoping to get a good impression. Now, I’ve discovered how to get a great
impression every time by creating my own texture sheets using Makin’s Clay®.
Makin’s Clay® is an air dry clay so the texture sheet does not have to be baked. It just dries out with the texture on it!
All of the Makin’s Clay® was rolled out to a #7 or a one card thickness before being placed on the texture plates or stamps.
These are Fiskars® Texture plates. They are made of hard plastic and will not go through a pasta machine. After I rolled the clay out, I placed the clay on the texture plate, put a piece of paper over the clay, and then ran it through a die cut machine as if it were an embossing plate. The clay will stick to the texture plate. Just put it aside until the clay dries and the clay will release from the plate. These is no need to use a release agent when you use the texture sheet with polymer clay.
These are hard plastic activity tops to a Rose Art Activity Desk. I picked the desks up at various yard sales for about 50 cents a piece! These desk tops are too large to go through the die cut machine so I placed the clay directly a texture on the desk top. Then, I used my fingers and pushed on the clay until I felt the entire pattern was pushed into the clay. I set it aside until the clay dried and loosened on its own from the plate.
This is just a rubber stamp. It is also too big to go through my die cut machine so I just pressed the clay onto the stamp and set it aside to dry. I did have to pull it off of the stamp but it came off with no problem.
